General

Physical properties

Technical data

Performance data

Caution. Never use Electrosolv-E on a running generator or motor. Electrosolv-E can be used to clean virtually all electrical equipment and components although it may affect some types of rubber and plastic. Either remove rubber and plastic parts from component or test on small area for any reaction before cleaning.
After cleaning motors or generators insulation resistance to ground should be tested to check that it is within its specified limits. Sprayers: a range of spray equipment is available for use with Electrosolv-E and other solvents.

Directions for use

Unitor™ Electrosolv-E™ must only be used in sufficient ventilated areas. Unitor™ Electrosolv-E™ should always be used undiluted. It can be applied by brush, swab or as a fine spray using suitable hand held spray equipment.

NOTE! Never open flame when using fine spray.

Small components be cleaned y brief immersion in a bath of Unitor™ Electrosolv-E™. The most suitable way of applying Unitor™ Electrosolv-E™ is by using hand spray or syphon spray gun. Once the deposits of dirt and grease have been flushed away with Unitor™ Electrosolv-E™ the remaining solvent may be evaporated by using clean compressed air at low pressure and high volume.

产品特性

• 不含氯化溶剂

• 强大的溶剂，蒸发控制

• 快速渗透

• 对电气绝缘无害- 在DIN-57370至209 KV / cm之后测试突破电压

优势

• 高效清洁，无油膜或水分残留

• 无腐蚀性- 可用于所有正常组件，不存在腐蚀性损坏风险

• 无需冲洗即可清洁和去除电气部件和设备的油脂

订购信息

Product number                                 Product name

604389                                               ELECTROSOLV - E 25 LTR

使用说明

Unitor™ Electrosolv-E™ 只能在通风良好的地方使用。.

Unitor™ Electrosolv-E™ 应始终不经稀释使用。它可以通过刷子，拭子或使用合适的手持喷雾设备作为精细喷雾施用。

NOTE! 使用精细喷雾时切勿打开火焰。清洁小部件，简单浸入

Unitor™Electrosolv-E™将小部件清洗干净，短暂浸泡在Unitor™Electrosolv-E™中。使用Unitor™ Electrosolv-E™最合适的方法是使用手动喷雾器或虹吸式喷枪。

一旦使用Unitor™Electrosolv-E™冲洗掉污垢和油脂沉积物，可以使用低压和高容量的干凈压缩空气蒸发剩余的溶剂。

稀释：

仅集中使用